Книги автора: Linux Network Administrator Guide, Second Edition
/ Книги автора: Linux Network Administrator Guide, Second Edition
Книга: Linux Network Administrator Guide, Second Edition
A Serial NULL Modem Cable
A Serial NULL Modem Cable
A serial null modem cable will work for both SLIP and PPP. Again, you will need two DB-25 connectors. This time your cable requires only eight conductors.
You may have seen other NULL modem cable designs, but this one allows you to use hardware flow control - which is far superior to XON/XOFF flow control - or none at all. The conductor configuration is shown in Figure B.2:
Again, if you have a shield, you should connect it to the first pin at one end only.
Figure B.1: Parallel PLIP cable
Figure B.2: Serial NULL-Modem cable
Оглавление статьи/книги
Похожие страницы
- Appendix B. Useful Cable Configurations
- A PLIP Parallel Cable
- Binary Serialization
- 2. Неопределенные значения (Null-значения)
- 3. Null-значения и общее правило вычисления выражений
- 4. Null-значения и логические операции
- 5. Null-значения и проверка условий
- Introduction to Serial Devices
- Maintaining Accurate Serial Numbers
- Chapter 4. Configuring the Serial Hardware
- 14.3.1. gdb Remote Serial Protocol
- 14.5.1. Early Serial Debug Output